ClubRalliart.com

ClubRalliart.com (http://www.clubralliart.com/index_forum.php)
-   2009+ Lancer Ralliart Troubleshooting, DIY and Inst (http://www.clubralliart.com/forumdisplay.php?f=12)
-   -   Boost Gauge wire routing (http://www.clubralliart.com/showthread.php?t=3368)

cetme 11-01-2012 06:51 AM

Boost Gauge wire routing
 
Hi guys and gals, I just got my AEM electronic boost gauge in the mail last night and I am trying to figure out the best way to get the wiring into the car. I am mounting the gauge on the steering column. I know how the gauge hooks up just don't know the best way to run wires into the cockpit. My car is a 2012 so the evo routing will not work if I did my research right. Any and all help would be GREATLY appreciated.

Thanks,

Wes

dem1983 11-19-2012 10:01 PM

oooh you're brave! I'm too nervouse to mess with any of the wiring, especially with how tempermental our cars can be. I just let the dealership take care of that, that way I know it's done right! Anything else I'll do, but not wiring. Good luck if you do try it :)

cetme 11-20-2012 10:20 AM

Yea, hooking the wires and gauge up are the easy parts. It is getting from point A to point B and make it look clean that is the tricky part. I will be attempting this this weekend and I will post pics once the install is done.

HTIEK 11-20-2012 11:00 AM

Mine is a 2010 so im not sure how similar our fire wall's are but if you have the stock intake....behind the intake pipe where it bends toward the turbo outlet a little lower there is a rubber gromet on the firewall where wiring already goes in i simply just forced mine in that hole and took a few under the dash pieces off to find it took me a while but was fairly simple i have a custom dual A pillar so i simply wired it in up the the pillar underneath the pedals..... here is a pic


http://sphotos-a.ak.fbcdn.net/hphoto...04405984_n.jpg

cetme 11-20-2012 11:08 AM

Nice job! Thanks I will look tonight I think 2010 &2012 should be the same. Thanks a ton!:D

HTIEK 11-20-2012 11:12 AM

Yea i removed my turbo outlet and stock air box to give me more room and it went smooth.

RALM 11-20-2012 02:44 PM

Quote:

Originally Posted by HTIEK (Post 40362)
Yea i removed my turbo outlet and stock air box to give me more room and it went smooth.

Yeah the instal is clean dude.

cetme 11-23-2012 10:26 PM

Hello all, I installed the gauge and it works.... It is a AEM electric gauge and when the car is idleing it reads 22 Inches of water? Instead of PSI:confused: When I give her some gas it will max out around 11-14PSI:mad:. Anyone know of this happening? I am planning on calling tomorrow if they are open, otherwise I will wait until monday , but any advice would be nice. By the way the car seems to be running fine.

Thanks,

Wes


All times are GMT -7. The time now is 06:15 PM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright (c) 2011 RnD Media LLC