evo x ic question

[dennis_svensson]

Hi will injen uicp fit an evo x fmic good? Do i need an uicp for ra or evo?

[Mkid]

Safest bet would be to get the Evo one and get a reducer coupler on the turbo side

[dennis_svensson]

Http://www.amsperformance.com/cart/a..._polished.html
I think this is what i need. On the bortom of the page it says.
The AMS Upper Intercooler Pipe will only fit the*AMS Ralliart FMIC or a Stock Evolution 10 FMIC

[OverCorrupt]

Last time i checked i had a Injen UICP for an Evo laying around. It has a decent sized scratch on it though. Hit me up if you want more info on it.

[dennis_svensson]

so im thinking of building my own uicp to a evoX fmic. cuz shiping it to sweden costs 500-600 USD.
so i just want to check is i got this size right.
Starting from the RA turbo, cup 1.74 to 2 (is this a good size for the pipe?)
Then 45°bend pipe to another 45°bend pipe.
Then farward in to the stock "elbow pipe"(90°) cup 2 to 2.
Then from the elbow down to the EvoX fmic Cup 2 to 2.5.
From EvoX fmic to the stock LICP 2.5 to 2.5.

anything wrong?

[OverCorrupt]

Just do 2.5" all the way. Thats what my current set up is. not sure on the bend degrees though.

[Markspd6]

Just buy EVO x stuff and use that, there's no gains from using a larger or aftermarket LIcP, and very little if any on the UICP, the IC will work fine for the stock turbo, if you wanna upgrade later? Wait and get an ETS 3" IC, that's good for most any turbos..

[dennis_svensson]

Its so hard to find here in sweden :-(

[dennis_svensson]

Just posting how to do the pipes again with the right cup.
from the RA turbo, cup 1.74 to 2 .Then 45°bend pipe to another 45°bend pipe.*Then farward in to the stock "elbow pipe"(90°) cup 2 to 2.Then from the elbow (that u need to cut off like 2 cm) to the EvoX fmic Cup 2 to 2.5.From EvoX fmic to the stock LICP 2.5 to 2.0!!