I've noticed a number of you guys have blacked out that chrome ring around the front grill. What did you do? Is a lot of maintenance required to keep it looking good? Thanks.
I went with vinyl strip tape route looks very clean and professional and wont have any wear in the future. Plasti dip will show wear in a long run from day to day driving. Vinal strip tape doesnt need bumper removal or ring removal
__________________
RA - Built head - Built SST - ID1000cc - GTX3576R - GSC S2 cams - GSC beehives/Ti retainers - Timing Chain kit - ARP head studs - AMS fuel rail - AMS Widemouth dp - TurboXS exhaust - DrivenFab oil catch can - MAP oil pan - MAP cast manifold - AEM wideband - COBB 3 port EBCS - Tial QRJ - Sakura 3.5 intake - Kozmic Walbro 450 fuel pump - Depo Racing fmic/licp - TS engine/exhaust mounts - Cusco bar - D2 RS coil - Megan Racing control arms/toe - Whiteline sway bars - Brembo 6 piston
You could also just pop the bubble and spray a light coat over that section again (just enough to hide the hole). The cool thing about plasti-dip is you can just spray over any areas that get damaged and it tends to blend in as long as the surrounding area is clean and not too faded.
__________________ Wedssport SA-55M 18X9 +20
CXRacing Evo X intercooler piping kit + BOV (Greddy Type-S)
Cobb AccessPORT Stage2 93 Octane
D2 RS Coilovers
Evo X FMIC
Ultimate Racing turbo-back
400HP clutches from Jack's
AEM Intake
looks very clean and professional and wont have any wear in the future. Plasti dip will show wear in a long run from day to day driving. Vinal strip tape doesnt need bumper removal or ring removal 
Linear Mode
